iPhone 11 Pentalobe Screws Replacement

This document serves as instructions for detaching or substituting the pair of screws that hold the iPhone 11 display assembly in place.These fasteners represent the sole external screws present on the iPhone's outer casing.Apple employs a distinctive five-point head design for these screws, necessitating the use of a specialized P2 pentalobe driver for their successful removal.The unique screw head geometry prevents the use of standard tools, ensuring that specialized equipment is required for service.Properly utilizing the correct P2 pentalobe driver is essential to prevent damage to the screw heads during the disassembly process.

Step 1 | Remove the pentalobe screws

Prior to commencing the repair process, ensure you take the following preparatory steps.

To mitigate potential hazards, allow the iPhone's battery to deplete to a level below 25% capacity.A fully charged lithium-ion battery presents a fire or explosion risk if it experiences accidental penetration.For safety and to prevent electrical shorts, completely de-energize the iPhone by powering it down.
Begin the disassembly by removing the pair of pentalobe screws, each measuring 6.7 mm in length, located along the iPhone's lower edge.
Be aware that separating the iPhone's display assembly will invalidate its water resistance.

To maintain the iPhone's ingress protection, either acquire replacement waterproof seals beforehand or exercise extreme caution to prevent liquid damage during reassembly if new seals are not used.